How to check your hydraulic breakers and work smoothly in the winter from wonepart?
How to check your hydraulic breakers and work smoothly in the winter from wonepart?
1. Comprehensive physical examination Before storing the hydraulic breaker, you should first conduct a safety physical examination on the hydraulic hammer breaker to check for malfunctions and loose screws and clean the whole hammer.
2. Replacing the rod seal can prevent impurities from contaminating the hydraulic system. Once the hydraulic breaker seal kits is broken, it is obvious that the breaker has oil leakage, and the operating pressure of the breaker may be insufficient due to internal leakage. Therefore, the small breaker needs to replace the seal kits when the working time is about 500 hours, while the large breaker needs to replace the oil seal between 300-400 hours of work, and pay attention to cleaning when replacing the hammer seal kits. Especially in winter, because of the cold weather, the sealing performance of the seal kits and diaphragm is not good, and more attention should be paid to the frequent replacement of the seal kits.
3. Precautions for placement The breaker should be placed in a dry indoor environment. It should not be placed in a humid, salt-alkali, or dusty environment for a long time. In order to prevent rainwater from entering, the rear cylinder should be raised, preferably stored in A room with low humidity. If it is not used for a long time, it is necessary to exhaust the nitrogen and use the drill rod to push the piston into the middle cylinder.
4. The maintenance cannot be stopped
The working environment of the breaker is very bad, and daily maintenance should be paid attention to in normal use. After removing the demoliton chisel, always check the wear condition of the bushing, through bolt in the lower cylinder, and check the piston, drill rod striking surface, chisel, inner jacket, etc.
The above is that after the breaker is not working, pay special attention to placing it. Breaking hammer is easy to cause damage to the machine due to long time storage.
Different breaker parts have different problems. We must conduct scientific and reasonable inspections according to the reasonable suggestions of engineers to replace the parts that need to be replaced to avoid larger problems and ensure safe operation of the breaker.
If you have any questions about any kinds of breakers, such as furukawa, NPK, Soosan, Atlas copco, montabert, kwangling, daemo, kent, sandvik,doosan, seal kits, membranes, chisel, pistons, bushings, and through bolts, you can contact us and we will answer you in time. At the same time, you can also visit our website www.wonepart.com/product-list/hydraulic-hammers , our engineer will support you at any time via emai info@wonepart.com.
