Hydraulic breaker nitrogen gas charging device

[product name]: Hydraulic breaker nitrogen gas charging device

[product brand]: ATLAS-COPCO、MONTABERT、STANLY、CHICAGO 、KRUPP、CAT 、KENT、NPK 、SOOSAN、JCB 、VOLVO 、FURUKAWA 、TOKU, etc.

[product model]: universal accessories, we could supply all brands and models of Hydraulic breaker nitrogen gas charging device

[product material]: mixed as per photo show

[product size]: international common size

[product price]: factory outlet

[customized products]: it can be customized based on the special size based on sample or detail drawing

Nitrogen bottle, nitrogen meter, 17-19-24-27-screwdriver. This is the required tool. The tools vary depending on the gun head. Before taking the nitrogen meter out of the box, it is best to take a picture with a mobile phone as shown in the picture, because the position is always incorrect when installed, so it is not easy to install This way to avoid installation errors.

Check nitrogen

Note: Before inflating, be sure to check whether the equipment is safe around; no gas other than nitrogen (N2) is allowed in the upper body. When filling the upper body with nitrogen (N2) and filling it into the upper body, do not approach the front of the steel brazing; when the filling is completed, the broken hammer steel will automatically extend.

1) After connecting the pressure gauge to the three-way valve, turn the handle of the three-way valve counterclockwise.

2) Connect the inflation hose to the nitrogen bottle.

3) After removing the screw from the breaker, install the three-way valve on the inflation valve of the upper body. (Ensure that the O-ring is fitted on the three-way valve)

4) Connect the other end of the inflation hose to the three-way valve.

5) Turn the valve handle on the nitrogen bottle counterclockwise to release nitrogen (N2), then slowly turn the three-way valve handle clockwise to the specified set inflation pressure.

6) Turn the three-way valve handle counterclockwise to close the three-way valve, then turn the valve handle on the nitrogen bottle clockwise to close the nitrogen.

7) The cap of the three-way valve should be fastened after the inflation hose is removed from the tee.

8) Turn the three-way valve handle clockwise to check the inflation pressure in the upper body again.

Note: When the steps of 1) to 8) are completed to inflate the upper body, the three-way valve handle should be turned counterclockwise, and then the three-way valve at the upper body inflation valve should be removed. However, if it is necessary to adjust the pressure in the upper body, it can be carried out according to the steps 9) to 13) mentioned below.

9) Remove the inflation hose from the three-way valve.

10) Install the three-way valve tightly on the inflation valve.

11) When the three-way valve handle is turned clockwise, the pressure value in the upper body will be displayed on the pressure gauge.

12) If the nitrogen pressure is low, repeat steps 1) through 8) until the pressure rises to the specified pressure.

13) If the nitrogen pressure is too high, slowly turn the regulator on the three-way valve counterclockwise, so that the air pressure is discharged from the upper body; when the pressure gauge shows the appropriate correct pressure value, the regulator should be closed clockwise. If the pressure is too high, the breaker will not work properly. Make sure that the air pressure meets the specified pressure value and that the O-ring is installed in the three-way valve.

There are different types of nitrogen gas tool and nitrogen table for different models of hydraulic breaker or rock hammers, if you are looking detail model like furukawa, soosan,krupp,atlas copco and so on, you could kindly visit our online http://www.wonepart.com/product/charging-kits  or email info@wonepart.com or whatsapp:+86-15860751932.

ISO9001 Certificate and CQC certificate

Factory Show